Five levers to reduce consumption
- 1
Monthly pump calibration
A poorly calibrated system can overdose without anyone noticing. Calibrate with a measuring cylinder every 30 days.
- 2
Migrate to a concentrated detergent
Biogold at 5–10 g per kg of dry laundry, according to soiling level.
- 3
Soften the water if it is hard
In hard water, part of the detergent is used up neutralising limescale. A water softener pays for itself quickly.
- 4
Dosing proportional to the load
If your machines have a weight sensor, enable load-proportional dosing so that small loads do not receive a full dose.
- 5
Replace peristaltic tubes on time
A worn tube lets more product through. Replace every 6–12 months depending on use.
How to calibrate a pump with a measuring cylinder
Calibration is the cheapest lever of all: all you need is a graduated cylinder, a few minutes per machine and a note of the result.
- Place the pump's suction lance in a graduated cylinder filled with the product.
- Trigger a dose from the programme or from the dosing unit's test mode.
- Read how much product has gone down in the cylinder and compare it with the programmed dose.
- If they do not match, adjust the pump's run time or flow rate and repeat until they do.
- Write down the date, machine, product and result.
Do this for every product and every machine: two pumps of the same model can dose differently, and the calibration changes after a tube has been replaced.
How to set the right dose
The dose is calculated per kilo of dry laundry, not per cycle. Biogold, for example, is dosed at 5–10 g per kg of dry laundry depending on how soiled it is. To translate that to your pumps:
- Start from the real load your customers put in, not the rated capacity: machines are rarely filled right up.
- Use the bottom of the range for lightly soiled laundry and the top for heavily soiled loads or hospitality linen.
- If you install a water softener, review the doses again: with softer water you will need less product.
- Adjust detergent and softener separately: each has its own dose on its technical data sheet.
Mistakes that push consumption up
- Programming the same dose on every machine regardless of capacity.
- Raising the dose to "mask" a bad smell that actually comes from the machine; what it needs is a clean with Machine Clean.
- Tubes with air in them or badly positioned lances that give irregular doses and lead people to increase them "just in case".
- Not recalibrating after changing a tube, a pump or the product.
Frequently asked questions
Does using less detergent make the wash worse?
Only if you go below the recommended dose. The saving comes from eliminating overdosing, not from underdosing.
How do I know if I am overdosing?
The clearest signs are excessive foam, harsh-feeling laundry or laundry with residue, and drums that run out sooner than expected. If you see several at once, start by calibrating.
How often do I need to recalibrate?
The guideline on this page is every 30 days and, in addition, whenever you change a tube, a pump or the product. In high season, also check the calibration as soon as you notice drums lasting less than usual.
Want to audit your current consumption?
Technical visit with a system analysis plus an optimisation proposal.
B2B PRICE · MANUFACTURER
Shall we send you our detergent and softener price list?
Price per pack size for self-service laundries and recommended dosage. We will reply to your request.