How a peristaltic pump works

A peristaltic pump uses rollers that sequentially compress a flexible tube, moving the liquid forward. The product only contacts the tube, never the mechanical parts. It is the most reliable and precise dosing system on the market.

Suitable for detergent as well as fabric softener, bleach or any chemical additive with controlled viscosity.

Key advantages

✓Precise dose per stroke
✓No contact with metal components · no corrosion
✓Simple maintenance: tube replacement every 6–12 months
✓Can run dry for short periods
✓Compatible with viscous and concentrated products
✓Low electricity consumption

Recommended maintenance

Tube replacementEvery 6–12 months, based on operating hours
CalibrationMonthly, using a graduated measuring cylinder
Connection checksWeekly (visual)
External cleaningMonthly, with a dry cloth
Service life8–12 years with proper maintenance

Compatibility with Instaquim products

Instaquim liquid products for automatic dosing:

How to calibrate a peristaltic pump, step by step

A monthly check with a measuring cylinder is the simplest way to know whether the dose you programmed is the dose that actually reaches the washer. It takes a few minutes, and it pays to use the same method every time.

  • Set up the measurement: take the suction lance out of the drum and place it in a graduated cylinder filled with the same product the machine uses.
  • Trigger one dose: start dosing from the dispenser's test mode or from the washer programme.
  • Read the volume: note how much product has left the cylinder and compare it with the dose programmed for that cycle.
  • Adjust and repeat: correct the pump run time and measure again until two readings in a row match.
  • Log it: write down the date, reading and adjustment on each machine's maintenance sheet. That is how you spot a tube that is starting to lose output.

Calibrate each pump with its own product: a detergent and a softener have different viscosities, so the pump does not move the same volume of each in the same time.

Signs that the tube is worn

  • The calibration reading drops compared with last month although nobody has touched the setting.
  • The tube looks flattened, cracked or feels sticky.
  • Drops or dried product appear around the pump head.
  • The suction line drains back into the drum between cycles, so the first dose arrives short.
  • Customers notice less fragrance or less softness: often the softener is not arriving in full.

Replace the tube with one of the material and diameter specified by the pump manufacturer. A different tube changes the volume moved per turn, so recalibrate after every tube change.

Common mistakes in self-service laundries

Badly placed suction lance

If the lance does not reach the bottom of the drum or its filter is missing, air gets into the line, the pump runs dry and the real dose falls, whatever the programme says.

Switching products without flushing

Before connecting a different product to the same line, flush the circuit with water. Instaquim product sheets state "Do not mix with other chemicals".

Tube not suited to bleach

A bleach such as Oximatic + is applied through an automatic peristaltic dispenser and is an acidic, oxidising product (stabilised peracetic acid). Check with the pump manufacturer that the tube on that line is suitable for this type of product.

Want to install peristaltic pumps in your laundry?

We advise on the number of pumps, capacity and optimum configuration.

B2B PRICE · MANUFACTURER

Shall we send you our detergent and softener price list?

Price per pack size for self-service laundries and recommended dosage. We will reply to your request.

Data processed by Detervic, S.A. to reply to you.